Roller blinds assembly manual.
Component breakdown
Facility
-
1
Check the measurements carefully to ensure a perfect fit.
-
2
Screw the brackets to the wall or ceiling.
-
3
Place the plastic caps that cover the screws.
-
4
Insert the roller grip pieces into the metal supports.
-
5
Proceed to place the roller, as seen in the image.
-
6
Insert the other end until it clicks.
-
7
Place the trims.
-
8
The installation is complete.
Uninstallation
-
1
Remove the trims.
-
2
With a flat screwdriver, lift the tab that releases the roller.
Chain assembly
-
1 - Turn the support until the two holes coincide, as shown in figure 1.
2 - Introduce the chain from the bottom and pass it around the axle.
-
3 - Tension the chain by pulling it downwards, as shown in figure 3.
4 - Turn the shaft to bring the chain into place and pull it down again to tighten it.
Chain replacement
-
1 - Turn the support until the two holes coincide, as shown in figure 1.
2 - Release the chain from the axle and pull it down to remove it from the support.
-
3 - Adjust the chain by turning the shaft.
4 - Pull the chain downwards to tension it and bring it into position.
Remember that if you wish, we can carry out the installation. You just have to fill out this form:
